Installation Guide

If copying/pasting, eye-drop this text to

ensure a uniform look for all installation

paragraphs.

1. On the drivers side remove the plastic

wing nut securing the trunk liner. Pull

back on the trunk liner to expose the

vehicles taillight wiring harness. Repeat

on the passenger side. Partially remove the

vehicles trunk scuff panel.

2. On the drivers side insert the T-connector

end with the yellow wire between the

separated connectors. Route the

T-connector end with the green wire to the

passenger side under the scuff panel.

3. Repeat step 2 on the passenger’s side.

Re-install the scuff panel.

4. Locate a suitable grounding point near

the connector such as an existing screw

with nut in the vehicle’s frame or drill a

3/32” hole and secure white wire using

eyelet and screw provided.

5. Route the 4-ﬂat wire to the center of the

vehicle and out the trunk when in use.

When not in use roll up and store in an out

of the way location in the trunk.

WARNING!

Verify miscellaneous items that may be

hidden behind or under any surface before

drilling to avoid damage and/or personal

injury.

02/10/09

55534

CHRYSLER 300

DODGE CHALLENGER

DODGE CHARGER

PAGE 1
55534 CHRYSLER 300 DODGE CHALLENGER DODGE CHARGER 02/10/09 1. On the drivers side remove the plastic wing nut securing the trunk liner. Pull back on the trunk liner to expose the vehicles taillight wiring harness. Repeat on the passenger side. Partially remove the vehicles trunk scuff panel. 2. On the drivers side insert the T-connector end with the yellow wire between the separated connectors. Route the T-connector end with the green wire to the passenger side under the scuff panel. 3.
PAGE 2