Installation Guide

A B C
D
Step 1
Locate the vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate. Locate the screws holding the driver
and passenger side taillights in place. The screws are located
by the hinge on the inside of the taillight (A,B).
Step 3
Starting on the driver side, remove the two screws using a
T-20 Torx bit. Loosen the taillight by gently pulling rearward
and out. Take care not to damage the alignment tabs (C).
Step 4
Locate the vehicle taillight wiring harness connectors.
The connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs.
Step 5
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place.
WARNING: Check for miscellaneous items that may
be hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the
ring terminal and provided screw.
Step 7
Route the custom wiring harness end with the green wire down
the opening behind the taillight on the drivers side (D). Route
harness containing the green wire underneath the vehicle up
through the opening behind the passenger side taillight.
Step 8
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 9
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 10
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55382-INS-RB • PAGE 2