Installation Guide

A B C
D
Step 1
Starting on the rear driver side, under the corner of the bumper,
locate the black plastic cover protecting the vehicle wiring
harness. Remove the two trim fasteners securing the cover (A,B).
Remove the cover. Repeat this process on the passenger side.
Step 2
Behind the removed cover locate the vehicle taillight wiring
harness connectors. The connectors will be similar to those
on the custom wiring harness. Starting on the driver side,
remove the foam tape from the vehicle connectors and separate
the connectors taking care not to damage the locking tabs (C).
Step 3
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (D).
Step 4
Route the custom wiring harness end with the green wire to the
passenger side. Repeat steps 2-3 on the passenger side using
the harness end with the green wire.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 7
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55363-INS-RA • PAGE 2