Installation Guide

Step 1
Open the vehicle tailgate.
Step 2
Remove the fasteners securing the rear scuff panel. Remove
the scuff panel by pulling out on the bottom and then up. Take
care not to damage the alignment tabs on the back.
Step 3
Remove the upper fasteners securing the driver- and
passenger-side interior trim panels. Carefully pry the
panels rearward and set them aside.
Step 4
Starting on the driver side, behind the removed trim panels,
locate the vehicle taillight wiring harness connectors. The
connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs.
Step 5
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 7
Route the custom wiring harness end with the green wire
to the passenger side behind the removed scuff panels.
Repeat steps 4 and 5 on the passenger side using the
harness end with the green wire.
Step 8
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 9
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 10
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55341-INS-RA • PAGE 2