Installation Guide

GROUND (WHITE)
BATT (BLACK)
STOP SIGNAL (RED)
ELEC BRK (BLUE)
ELECTRIC BRAKE CONTROL WIRING DIAGRAM
NEG POS
+
_
TRAILER CONNECTOR
AT REAR OF VEHICLE
BRAKE PEDAL
30 AMP
AUTO-RESETTING
CIRCUIT BREAKER
#10 RING
TERMINAL
3/8” or 1/2”
RING TERMINAL
CAUTION!!!
DISCONNECT TOW VEHICLES
NEGATIVE(-) BATTERY CABLE
BEFORE INSTALLATION OF
BRAKE CONTROL WIRING
BREAK PEDAL SWITCH
CONNECT TO COLD(SWITCHED) SIDE
“ONLY ON WHEN PEDAL IS DEPRESSED”
WIRE TAP
WARNING!!! READ AND FOLLOW ALL WARNINGS AND
CAUTIONS PRINTED ON TOW VEHICLE BATTERY
ATTENTION: ALL 1989-1991 FORD E & F-SERIES VANS
AND TRUCKS WITH ANTI-LOCK BRAKES.
DO NOT CONNECT TO BRAKE PEDAL SWITCH.
SPLICE THE RED STOP SIGNAL WIRE FROM THE BRAKE
CONTROLLER TO THE LIGHT GREEN WIRE ON THE TURN
SIGNAL HARNESS USING A WIRE TAP.
LIGHT GREEN WIRE
TURN SIGNAL HARNESS CONNECTOR
LOCATED UNDER THE VEHICLE’S DASH
NEAR THE STEERING COLUMN.
12-10 GA BUTT CONNECTOR