Installation Guide

A B
INSTALLATION
Step 1
Locate the grey, vehicle brake control harness connector to the
right side of the steering wheel, underneath the dash, taped to
another harness. The connector will be similar to that on the
CURT brake control harness. If there is foam padding on the
connector remove it for install.
Step 2
Insert the connector on the CURT brake control harness into
the vehicle connector. Make sure the connector is fully inserted
with locking tabs in place (A).
Step 3
Insert the brake control harness's black connector into the
brake control's quick plug connector (B). Secure the brake
control harness with the provided cable ties, avoiding any
pinch points.
Step 4
Complete the installation using the brake control instructions.
Mount the unit as directed and perform test procedures as
instructed in the brake control user manual.
CURTMFG.COM • NEED ASSISTANCE? • 1.800.798.0813 • 51457-INS-RA • PAGE 2