Installation Guide

Gas

Brake

E-brake

BH2

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51457 APPLICATIONS

Scan for helpful

installation tips

NOTE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Ram 1500

Ram 2500

Ram 3500

BH2 - Under dash, to right of steering column

Representative vehicle shown below

BRAKE CONTROL HARNESS

LOCATION GUIDE

PAGE 1 • 51457-INS-RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51457 APPLICATIONS Make Model Ram 1500 Ram 2500 Ram 3500 NOTE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION Step 1 Locate the grey, vehicle brake control harness connector to the right side of the steering wheel, underneath the dash, taped to another harness. The connector will be similar to that on the CURT brake control harness. If there is foam padding on the connector remove it for install. Step 2 Insert the connector on the CURT brake control harness into the vehicle connector. Make sure the connector is fully inserted with locking tabs in place (A).