Installation Guide

Gas

Brake

E-brake

BH8

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51438 & 51439 APPLICATIONS

Scan for helpful

installation tips

NOTICE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Dodge Ram 1500

Dodge Ram 2500

Dodge Ram 3500

BH8 - Under dash, to right of emergency brake pedal

Representative vehicle shown below

LOCATION GUIDE

PAGE 1 • RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51438 & 51439 APPLICATIONS Make Model Dodge Ram 1500 Dodge Ram 2500 Dodge Ram 3500 BRAKE CONTROL HARNESS NOTICE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the 4-pin, vehicle brake control harness connector under the dash, to the right of the emergency brake pedal. It will be taped to another harness. The connector will be similar to that on the CURT brake control harness (A). Step 2 Insert the connector on the CURT brake control harness into the vehicle connector. Make sure the connector is fully inserted with locking tabs in place (B).