Installation Guide

Gas

Brake

E-brake

BH1

INSTALLATION INSTRUCTIONS

51362 & 51363 APPLICATIONS

Scan for helpful

installation tips

NOTICE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

BH1 - Under dash, left of steering column, near emergency brake pedal

Representative vehicle shown below

LOCATION GUIDE

BRAKE CONTROL HARNESS

Make Model

Lexus GX 460

Lexus GX 470

Lexus LX 470

Lexus LX 570

Make Model

Toyota 4Runner

Toyota Land Cruiser

Toyota Sequoia

Toyota Tacoma

Toyota Tundra

PAGE 1 • RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51362 & 51363 APPLICATIONS Make Model Make Model Lexus GX 460 Toyota 4Runner Lexus GX 470 Toyota Land Cruiser Lexus LX 470 Toyota Sequoia Lexus LX 570 Toyota Tacoma Lexus LX 570 Toyota Tundra BRAKE CONTROL HARNESS NOTICE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the 5-pin, vehicle brake control harness connector under the dash, to the left of the steering column. It will be taped to another harness near the emergency brake pedal. The connector will be similar to that on the CURT brake control harness. Step 2 Insert the connector on the CURT brake control harness into the vehicle connector. Make sure the connector is fully inserted with locking tabs in place.