Installation Guide

Gas

Brake

E-brake

BH1

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51332 & 51333 APPLICATIONS

Scan for helpful

installation tips

NOTICE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Chrysler Aspen (w/ factory tow package)

Dodge Dakota (w/ factory tow package)

Dodge Durango (w/ factory tow package)

Dodge Ram pickup, full-size

Ram Dakota (w/ factory tow package)

BH1 - Under dash, left of steering column, near emergency brake pedal

Representative vehicle shown below

LOCATION GUIDE

PAGE 1 • RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51332 & 51333 APPLICATIONS Make Model Chrysler Aspen (w/ factory tow package) Dodge Dakota (w/ factory tow package) Dodge Durango (w/ factory tow package) Dodge Ram pickup, full-size Ram Dakota (w/ factory tow package) BRAKE CONTROL HARNESS NOTICE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the 4-pin, vehicle brake control harness connector under the dash, to the left of the steering column. It will be taped to another harness near the emergency brake pedal. The connector will be similar to that on the CURT brake control harness. Step 2 Insert the connector on the CURT brake control harness into the vehicle connector. Make sure the connector is fully inserted with locking tabs in place.