Installation Guide

CURTMFG.COM
•
PRODUCT SUPPORT: 877.287.8634
•
11591-INS-RA
•
07/27/2020
•
ECN7262
•
PAGE 3
Step 2
Using short Philips and flathead screwdrivers,
remove the screws and plastic rivets in the
fascia panel as shown.
Step 3
Gently pull the fascia up from the rear
wheel trim panel on each side of the vehicle.
Work up to the taillights and continue to
remove along the bottom of the taillights
to the bottom of the trunk.
After the panel is loose all around,
remove the bumper fascia and set it aside.
Step 4
Remove the eight bolts securing the bumper.
CAUTION
Hold the bumper while removing the last two
bolts on each side to avoid the bumper dropping.