Installation Guide
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12 - 1.25 x 40 HEX21
LOCK WASHER1/2"62
WASHER7/16 WASHER23
HANDLE NUTM12 - 1.25 HANDLE-NUT24
HEX TAP BOLTM12-1.25 x 30mm45
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
7
45
11/26/2012
11646
120
217382
1. Position the hitch on the bumper so the front bracket holes align with the threaded holes in the front face of
the bumper. Mark the metal retainer strip and plastic fascia at the bottom of the bumper. This area
(approximately 1 1/2 x 8") must be clear for the bracket to fit directly against the metal bumper. Use a 10mm
wrench to remove the retainer from the bumper, and trim marked area with a sharp knife.
2A. Note the holes in the bottom of the metal bumper that match the holes in the hitch bumper bracket. For
those bumpers with match 12mm weldnuts, the hitch can be bolted directly in place using 12mm
bolts and washers called out. If the car does not have threaded holes in the bottom surface; go to 2B.
2B. Some bumpers will have smaller threaded holes (weldnuts) for the retainer or no holes at all matching the
holes in the hitch bracket. Remove the two small weld nuts (if any). Use the hitch as a template to drill
matching 1/2" diameter holes in the metal bumper. Fasten the hitch at these holes as shown.
3. Torque all 12mm fasteners to 86 lb-ft.
EXISTING WELDNUTS
(2A)
NO EXISTING WELDNUTS
OR ENLARGED HOLE
(2B)
5
2
3
2
1
4
METAL BUMPER BEAM
- HOLE ENLARGEMENT
- DRILLING MAY BE REQUIRED
EXISTING WELDNUTS
87-91 TOYOTA CAMRY SEDAN & WAGON, 86-89 TOYOTA CELICA,
87-88 TOYOTA CRESSIDA SEDAN, 86-89 TOYOTA SUPRA