Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,1/2-13 UNC,2,GRD8,YZ10-1028861
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006262
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1123
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6,000
600
36
45
10,000
1,000
13028 / RRH13028
5/21/2020
1) Remove spare tire and rear bolt on tire holder. Clean mounting surface as needed.
2) Place spacers between hitch and frame as shown (clamp hitch into position). Using the hitch as a template,
mark and drill 1/2" mounting holes. Make sure wires and hoses will not be damaged when drilling.
NOTE: hitch must be positioned so end of receiver tube is flush with back of vehicle.
3) Install fasteners as shown above, and remove clamps.
4) Torque all 1/2" fasteners to 110 lb-ft.
5) Re-install spare tire and removed hardware if possible.
USE SPACERS WHEN
NEEDED TO LEVEL HITCH
PASSENGER SIDE
FRAME RAIL
DRIVER SIDE
FRAME RAIL
3
2
3
1
-REMOVE SPARE TIRE
-DRILLING REQUIRED
-RE-INSTALL SPARE TIRE
88-91 CHEVY/GMC 4 DR CREW CAB ONLY 73-79 FORD 250 CREW CAB
73-06 CHEVY/GMC FULL SIZE CAB & CHASSIS w 34" FRAME 73-06 FORD PICKUP: CAB AND CHASSIS 34" frame width
62-87 CHEVY/GMC ALL FULL SIZE: except 10" bumper