Installation Guide

56464-INS-RA
•
04/20/2021
•
ECN8142
•
PAGE 3 OF 4
Step 4
Staring on the driver side, pull out on the
interior side panel to locate the vehicle
taillight wiring harness. Take care not to
damage the alignment tabs on the back.
Step 5
Locate the vehicle taillight wiring harness
connectors. The connectors will be similar
to those on the custom wiring harness.
Separate the connector from the taillight
housing taking care not to damage the locking
tabs. Insert the custom wiring harness end
with the yellow wire between the separated
connectors. Make sure the connectors are
fully inserted with locking tabs in place.
Step 7
Route the custom wiring harness end with the
green wire down behind the interior side panel
and out to the passenger side behind the removed
scuff panel. Repeat steps 4 through 5 on the
passenger side using the harness end with the
green wire. Locate a flat spot inside the vehicle,
near the taillight. Adhere the black converter
box using the provided double-sided tape.
Secure any loose wires
with the provided cable ties.
Step 8
Route the black power wire from the vehicle battery as shown on the last page of this manual.
When in use, route the 4-flat to the center of the vehicle and out of the trunk.
When not in use, roll up and store in a convenient, out of the way location inside the trunk.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.
Step 6
Locate a grounding point near the box such as an existing screw or bolt in the frame
of the vehicle or drill a 3/32"pilot hole. The area should be free from rust, dirt, and paint
(abrasive pad/paper to remove rust and paint). Secure the white ground wire with the
ring terminal on the existing fastener or with the provided ground screw.
CAUTION
Check for miscellaneous items that may be hidden behind or under
any surface before drilling to avoid damage and/or personal injury