Installation Guide

58970-INS-RB
•
PAGE 2
Step 1
Locate the vehicle battery. Look up the
battery location in the owner's manual of
your vehicle. Disconnect the negative battery
terminal. Be sure to fasten this wire down
and away from the battery when completing
the installation process.
Step 2
On the rear driver side between the frame rail
and the spare tire, locate the harness. The
harness will be similar to your new RV harness
product. Separate the harness from the mating
housing by releasing the locking tabs.
Step 3
Install the custom RV harness
in between the factory wiring.
Step 4
Route the 4 flat wire above the frame rail
on the driver side to the front of the vehicle.
Use the provided cable ties to loosely secure
the wire along the frame rail as needed.