Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
NUT,HEX,M14x2,CL10,YZ20-0018521
HHCS,M8x1.25,30,CL10.9,YZ
10-1044022
5/16" LOCK WASHER, YZ
30-0021923
1/4" WASHER30-0018824
WASHER,LOCK,9/16,YZ30-001942
5
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
24
10
JEEP SRT 8
10/22/2020
11103
20
24814 / 247103
1. Raise hitch into position as shown. Slide the rear bracket over existing 14mm studs protruding from the
bumper. Do not remove existing 14mm nuts.
2. Push the hitch up to make contact with the floor rib of the vehicle. Install (2) 8mm bolts with washers and
lock washers into existing weldnuts.
3. Install (2)14mm nuts with lock washers onto existing studs at the bumper beam.
4. Torque all 14mm fasteners to 126 lb-ft, and all 8mm fasteners to 23 lb-ft.
-NO DRILLING REQUIRED
-NO FASCIA TRIMMING REQUIRED
5
3
4
2
1
DESIGNED FOR USE WITH
BALL MOUNT # D-221 / 45522
**CAUTION**
HITCH, BALL MOUNT, HITCH PIN AND HITCH PIN CLIP
MAY BECOME HOT DURING VEHICLE OPERATION.
USE CAUTION WHEN INSTALLING OR REMOVING
ANY BALL MOUNTS OR ACCESSORIES.