Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
7. Enlarge front (2) holes where rubber plugs were
removed in Step 6 with die grinder. Enlarge only
enough to allow CM-SP6 spacers and 1/2"
carriage bolts to pass through.
8. Fishwire 1/2" carriage bolts and CM-SP6
spacers through enlarged holes and out
rear mounting holes using supplied
fishwire tools.
9. Raise hitch into position and secure hitch
to vehicle with 1/2" hex flange nuts on
fishwired bolts from Step 8. Only hand
tighten bolts at this time with 3/4" socket.
10. Center hitch on vehicle. Using the hitch
as a template, drill front (2) holes in
frame rails. Drill one hole per frame rail
using a 17/32" drill bit
DRILL HOLES