Installation Guide

58981-INS-RA
•
10/14/2020
•
ECN7154
•
PAGE 1 OF 2
Wiring Location Guide*
Front bumper
* Representative vehicle shown
INSTALLATION MANUAL
Tools Required
Ratchet Panel trim
removal tool
Socket Cutting tool
Socket extension Wire crimper
Torx bit Wire stripper
Wrench Heat gun
Phillips screwdriver Paint marker
Flathead screwdriver Electrical tape
* Tools vary based on vehicle
Product Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.