Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
7. Install hitch on rear of vehicle frame using existing studs.
Reinstall bumper beam over hitch. Loosely secure with
existing vehicle hardware.
9. Trim underbody panel as shown in the trim diagram using
aviation shears.
NOTE: All dimensions are approximate, confirm fit prior to
trim.
NOTE: Removing (2) corner crush tabs (1) on each side of
fascia may ease installation.
8. Torque all M10 hardware to 45 ft-lbs.
10. Reinstall rear bumper fascia removed in step 5. Reinstall
taillights removed in step 4. Reinstall trunk liner guard
removed in step 3. Reinstall underbody panel removed in
step 1. Reinstall all fasteners removed.
Installation complete.