Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
3. Inside the trunk along the plastic liner guard use plastic pry
bar to remove (2) caps, (1) on each side, to access and
remove (2) bolts, (1) on each side, using T-45 Torxbit
Socket. Gently remove plastic trunk liner guard and set
aside for reinstallation.
4. To access taillight removal, remove (4) plastic clips, (2) on
each side. To remove taillights, pull back trunk carpet locate
and remove (8) nuts using 8mm socket, (4) on each side.
Unclip electrical harness and gently remove taillight, set
aside for reinstallation.
5. Gently remove rear bumper fascia by releasing the press-in
tabs along top portion of bumper fascia. Unclip
motion sensor harness. Set aside for reinstallation.
6. Remove the bumper beam by removing (2) nuts and (2)
bolts using 13mm socket, on each side. Set aside bumper
beam for reinstallation.