Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
1. Remove underbody panel by removing (3) nuts using a
10mm socket and remove (12) screws along outer edge
of fascia using T-15 Torxbit Socket. Set underbody panel
aside for trim and reinstallation.
2. Pull back wheel well cover to remove (4) screws (2) on
each side using 7mm socket.
VEHICLE FRAME
EXISTING STUDS
(BOTH SIDES)
EXISTING WELD NUTS
(BOTH SIDES)
EXISTING VEHICLE HARDWARE
(BOTH SIDES)
EURO MOUNT
OPTION AVAILABLE
#45571 (1 7/8" BALL)
#45572 (2" BALL)
DESIGNED FOR USE WITH
BALL MOUNT #45521