Installation Guide
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM10 - 1.25 x 3021
WASHER7/16 WASHER32
HELICAL LOCK WASHER7/16 LOCK WASHER23
HEX BOLT7/16-14 x 2.00"14
HEX FLANGE NUT7/16-1415
.25 x 2.00 BACKING PLATECM-11143-BP16
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
7
30
11/26/2012
11143
60
217203
1. Locate two existing 10mm threaded holes at the bottom of the rear bumper (metal beam inside the fascia).
Notice the clearance holes in the bumper fasica near the license plate area.
2. Fasten the hitch to the car's bumper at these 10mm holes using fasteners as shown. Be certain to use the
flat washers under the heads of the screws.
3. The loop bracket on the hitch locates to the driver's side of the car's tie down loop. Use the backing plate
provided to sandwich the car's tie down loop. Use fasteners in position # 1 on four door cars, and position
# 2 on 3 door models.
4. Torque all 7/16" fasteners to 70 lb-ft.
1
2
6
2
4
5
2
3
1
TOW LOOP BRACKET
METAL BUMPER BEAM
-NO DRILLING REQUIRED
90-91 ACURA INTEGRA HATCHBACK / 90-93 INTEGRA SEDAN