Installation Guide

A B C
D
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate. Remove the two plastic fasteners
holding each taillight assembly in place. Remove both taillights
taking care not to damage the locking tabs (A).
Step 3
Starting on the driver side, locate the vehicle taillight wiring
harness connectors (B). The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs.
Step 4
Insert the custom wiring harness end with the yellow, red and
brown wires between the separated connectors (C). Make sure
the connectors are fully inserted with locking tabs in place.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Route the custom wiring harness end with the green wire
under the vehicle, through the opening under the taillight,
over to the passenger side along the backside of the bumper
and up through the opening under the passenger side taillight.
Repeat steps 3 and 4 on the passenger side using the harness
end with the green wire.
Step 7
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 10
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56330-INS-RA • PAGE 2