Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6,000 600
34
15
CHEVROLET TAHOE PPV
08/21/2020
13161
30
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HHCS,M14x2,50,CL10.9,YZ10-1052461
WASHER,S-CON,9/16,YZ30-0016462
PASSENGER SIDE FRAME RAIL
DRIVER SIDE FRAME RAIL
2
1
EXISTING
WELDNUT
1. If present, remove (6) existing bolts from both frame rails and discard. Clean weldnuts as necessary with
spray lubricant and small wire brush.
2. Lift hitch into place and install (6) M14 bolts and conical washers as shown.
3. Torque all M14 fasteners to 150 lb.-ft.
NO DRILLING REQUIRED
WELDNUT CLEANING
TOOLS REQUIRED
21mm SOCKET
RACTHET
TORQUE WRENCH
SAFETY GLASSES
SPRAY LUBRICANT