Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Remove fascia mounting brackets by first removing plastic
clips on bottom of fascia and then unbolting brackets from
bumper. Retain for reinstallation after hitch installation.
4. Locate center of vehicle fascia and mark area as shown
for fascia trimming, approximately 2 1/2" x 1 3/8". Trim
fascia.
5. Raise hitch into position and secure with M12 x 1.25 x 30mm
hex bolts and 1/2": conical toothed washers into existing
weldnuts. Torque all M12 fasteners to 86 ft-lbs.
6. Reinstall fascia mounting brackets.
7. Raise spare tire back into position.
Installation is complete.
1 3/8"
2 1/2"