Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

10mm socket

1/4" socket

T-20 Torx bit

Ratchet

Panel trim removal tool

Crimping tool

Wire cutters

Cutting tool

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Ford Focus hatchback

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

PASSENGER CARS

(

)

Representative vehicle shown below

P1 - Behind driver side taillight housing, outside of trunk

P2 - Behind passenger side taillight housing, outside of trunk

P1 P2

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

PAGE 1 • 56273-INS-RB

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Ford Focus hatchback WIRING LOCATION GUIDE PASSENGER CARS (P) Representative vehicle shown below P1 - Behind driver side taillight housing, outside of trunk P2 - Behind passenger side taillight housing, outside of trunk CUSTOM WIRING HARNESS P1 P2 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate vehicle battery on the driver side under the hood and disconnect the negative battery terminal (A). Step 2 Open the vehicle tailgate. Remove all trunk floor coverings and storage trays (B). Step 3 Remove the push fasteners securing the rear scuff panel (C). Remove the scuff panel by pulling out on the bottom and then up taking care not to damage the alignment tabs on the back.