Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ
10-1027241
HHCS,M8x1.25,35,CL10.9,YZ
10-1039322
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006243
WASHER,S-CON,3/8,YZ
30-0014824
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP6
4
5
1/2" FISHWIRE1_2 FISHWIRE
16
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
27
20
00-05 CADILLAC DEVILLE AND 06-PRESENT DTS
8/13/2020
12058
40
36287
1. Raise hitch into position.
2. Install two M8 bolts into existing weldnuts as shown.
3. Fishwire remaining fasteners as shown. Note: 1/2" bolt and block must be inserted
separately into access hole during fishwiring process.
4. Torque M8 fasteners to 23 lb.-ft. Torque all 1/2" fasteners to 110 lb.-ft.
5
3
2
4
1
-NO DRILLING REQUIRED
1 GENERIC INSTRUCTION SHEET 7/5/2007 DWS
2
CHG TO GRADE 8 TORQUE SPECS
7/18/2012
AJP
3
UPDATED HARDWARE
DESCRIPTIONS/NUMBERS
8/13/2020 CJW
REVISION HISTORY
REV DESCRIPTION DATE APPROVED
DESIGNED FOR USE WITH
BALL MOUNT # D-21 / 45521
ACCESS HOLE
EXISTING WELDNUT
6