Installation Guide

Step 1
Remove protective plastic end caps. Slide the front (#1) and
rear (#2) baskets together. Attach the side and rear plates
(#9), as shown in figure 3. The rear plate is attached with one
short bolt (#13). The side plates are attached with two machine
screws on each side (#7). Position the basket on the roof bars
of the vehicle.
Step 3
To install the fairing (#10), snap the top and bottom clips (#11, #12)
onto the top and bottom tubes of the rack as shown in figure
7 and 8. Place the spacer tubes (#15) behind the fairing, in
between the bottom clips and the fairing.
Step 4
Center the fairing and secure using the provided
nuts (#16) and bolts (#13 and #14). See figure 8.
Step 2
Snap the saddle (#5), onto the basket as shown in figure 4.
The saddle must sit on the cross bars of the vehicle.
Secure it with the bracket top plate (#4), knobs (#5)
and U-bolts (#6). See figure 5.
Note: Always position the saddles away from the
center for maximum support as shown in figure 6.
ASSEMBLY & INSTALLATION
Figure 3
Figure 5Figure 4
Figure 6
Figure 7
Figure 8
CURTMFG.COM • NEED ASSISTANCE? • 877.287.8634 • 18115-INS-RE • PAGE 2