Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006241
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP1242
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ10-1027243
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
34
30
00-07 FORD FOCUS WAGON
1/22/2021
11296
60
24682
1) Slide the rubber exhaust hanger off of exhaust hanger hook.
2) Bend corner of muffler heat shield down to increase clearance to access hole on driver's side frame.
3) Raise hitch into position and loosely install the rearward fasteners.
4) Fishwire carriage bolt and block thru access hole in frame rail, both sides, as shown.
5) Install remaining fasteners as shown.
6) Reattach rubber exhaust hanger.
7) Torque all 1/2" hardware to 110 lb.-ft.
2
1
3
NO DRILLING REQUIRED
DESIGNED FOR USE WITH
BALL MOUNT # D-224