Installation Guide
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6
5
CLAMP ON CHAIN HANGERS
7/27/11
17003
10
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HANGER WELDMENT17003-00321
F-4 CLIPCM-F4C22
HEX BOLT1/2-13 x 2"23
HEX TAP BOLT1/2-13 x 3 1/2" HEX TAP BOLT24
2
4
3
- NO DRILLING REQUIRED
1. Place hanger weldment on top of the trailer frame directly above the chains of the weight distribution hitch.
2. Install bolt as shown above, do not over tighten. Repeat for other side.
OPERATION INSTRUCTIONS:
1) With trailer attached to the vehicle, raise the trailer tongue and
vehicle with the jack.
2) Hang the closest chain link over the hanger on both sides as
shown above.
3) Lower vehicle to make sure the vehicle and trailer are in
alignment. Once aligned, insert the F-4 CLIPs.
AS SEEN IN
OPERATION
1