Owners manual

CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CURT MANUFACTURING does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
responsibility of the installer to prevent damage due to installation.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
16422
2009-2010 DODGE RAM 1500
Page 3 of 3
2/11/2013
MOUNTING CHANNEL
29" SHORT BOX
31" LONG BOX
DRILL (2) CENTER HOLES
SHOWN IN ADDITION
TO (8) HOLES FOR MOUNTING
PLATES AND OTHER
HARDWARE. INSTALL 1/2"
BOLTS AND U-SHAPED
SPACERS ABOVE OR BELOW
BED TO FILL BED CORRUGATIONS
AND BOLT PLATE BELOW BED
WITH WASHERS AND NUTS.
FRONT MOUNTING BRACKET
REAR MOUNTING BRACKET
KING PIN CENTER
APPROX. 1-1/2" FORWARD
OF AXLE CENTER
Front
of
Vehicle
REAR EDGE OF
TRUCK BED BED
(NOT TAILGATE)