Installation Guide

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
16307
RAM 1500
3 OF 3
WARNING:
- Do not install mounting rails over plastic bed liners. Plastic liners must be trimmed for metal to metal contact.
(Mounting rails may be installed on spray on liner.)
- Use only supplied fasteners for installation.
- Before installing mounting rails and hitch, measure to be sure there will be enough clearance between the truck and trailer to allow for turns.
**BE SURE TO COMPENSATE
FOR THE THICKNESS OF THE
SPRAY-IN BED LINER IF
PRESENT**
SHOWN WITH CURT 16180 5TH WHEEL
(SOLD SEPARATELY)
CAB
TAIL GATE
SHORT BED ONLY
(EXCLUDING 8' BED)
28 7/8"
CAB
TAIL GATE
INSTALL FASTENER IN THIS
LOCATION FOR AIR SUSPENSION
INSTALL FASTENER IN THIS
LOCATION FOR COIL SPRINGS
USE HANDLE NUT AND HEX HEAD BOLT
ON AIR RIDE EQUIPPED MODELS
(BOTH SIDES)
INSTALL 2" HEX HEAD
BOLTS IN THESE LOCATIONS