Owners manual

10
ReinstalltheQ205thWheelinthereverseorderitwasremoved.Ifremovalmethodwasperoption 1, please follow the steps below:
a.PlacetheMid-SectionstillsecurelyboltedtothelegsintotheMountingRails
b.Insertthe(4)MountingRailPins.
c. Install the (4) Hairpin Clips.
d.Retorque(4)PilotHexBoltsto100ft-lb.
IMPORTANT:Wheninstallingthe5thWheelHeadintotheMid-Section,theLONGENDoftheBearingShaftisinsertedintotheLower
BearingAssembly.TheMachinedBearingRetainermustbeagainsttheLowerBearingAssembly.TheRemovableBearingRetainer
mustbeagainsttheothersideoftheLowerBearingAssembly.TheO-RingRetainerStopisplacedinitsgroovelastly.
ApplyalightfilmoflubricanttotheLowerPilot.GuideLowerPilotintoMid-SectionwhileholdingBearingShaftanditsRetainers
against Lower Bearing Assembly. Continue to guide Lower Pilot through the Lower Square Pad until the Bearing Shaft is fully seated in
its Saddles. Place Shaft Caps over the Bearing Shaft. Install the two long Pins and insert two Hair Pin Clips. See diagrams below.
reInstallatIon
Ensure that the Machined Bearing Retainer
and the Removable Bearing Retainer are
against Lower Bearing Assembly. Both sit
inboard of Mid-Section Bearing Shaft Cradles
during assembly.
Bearing Shaft With
Machined Bearing Retainer
O-Ring
Removable Bearing Retainer
Add a Light Film of Lubricant
to Ease Assembly
Correct installation of
Pins and Hair Pin Clips
Bearing Shaft
Caps