Owners manual

TOYOTA TUNDRA 2000 TO 2006 (STANDARD CAB LONG BOX ONLY)
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
NOTE: For Toyota Tundra application, part #16302 spacer kit is required. Stack (1) 3/16” and (1) 5/16” thick slotted
spacers as required to avoid crushing of truck bed.
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CURT MANUFACTURING does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
responsibility of the installer to prevent damage due to installation.
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
Front
of
Vehicle
Measure from rear
edge of truck bed to
rear edge of mounting
rail
Rear Edge of
Truck Bed
32 1/2" Long Box
(only)
King Pin Centered approximately
1 1/4" forward of Axle Center
Axle Center
Mounting Channel
Long bracket
Short bracket
Drivers side shown
*Optional weld
pattern
.25 1.5-3
.25 2
*
.25
2
.25 2
*
19
Each mounting rail must have
a bolt in either of the marked
center holes. Check for
obstructions before drilling.
Front
of
Vehicle