Owners manual

DODGE THROUGH 93 (FULL SIZE)
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. You may need to move mounting rail location +/- ½” to ensure frame brackets do not interfere with bed sills.
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CURT MANUFACTURING does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
responsibility of the installer to prevent damage due to installation.
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
Front
of
Vehicle
Measure from rear
edge of truck bed to
rear edge of
mounting rail
Rear Edge of
Truck Bed
29 5/8" Long Box
and Short Box
Axle Center
King Pin Centered over Axle
Mounting Channel
Long bracket
Bed Sill
Short bracket
*Optional weld pattern
Drivers side of 1/2 ton Ram shown
.25
2
.25 2
*
.25 1.5-3
.25 2
*
17
Each mounting rail must have
a bolt in either of the marked
center holes. Check for
obstructions before drilling.
Front of
Vehicle