Owners manual

DODGE ’94 TO ’01 1500, ’94 TO ’02 2500/3500 (FULL SIZE, SHORT AND LONG BOX)
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. It is very important that brackets in Row 2 are against forward side of bed sill as shown below. Due to dimensional instability
in bed sill placement with the Dodge truck, interference could result when drilling in Rows 3 or 4. You may need to move the
mounting rail location +/- ½” to ensure frame brackets do not interfere with bed sills.
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CURT MANUFACTURING does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
responsibility of the installer to prevent damage due to installation.
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
Front
of
Vehicle
Measure from rear
edge of truck bed to
rear edge of
mounting rail
Rear Edge of
Truck Bed
32 7/16" Long Box
28 7/16" Short Box
King Pin Center approximately
2" forward of Axle Center
Mounting Channel
Long bracket
Bed Sill
Short bracket
Drivers side Ram 1500 shown
.25 1.5-3
.25 2
*
.25
2
.25 2
*
16
Axle Center
Each mounting rail must have
a bolt in either of the marked
center holes. Check for
obstructions before drilling.
Front of
Vehicle