Installation Guide

CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8 634
•
RA
•
PAGE 20
.25 1.5-3
.25 2
*
.25
2
.25 2
*
Front of truck
Row 1 Row 2 Row 3 Row 4
Rear edge of truck bed
Each base rail must have a bolt in
either of the marked holes. Check
for obstructions before drilling.
Rear edge of the truck bed to
the rear edge of the base rail.
32-1/2" long box
Axle center
Short bracket
VEHICLE-SPECIFIC INSTALLATION
Toyota Tundra, standard cab 00 - 06 (long box only)
Long bracket
Mounting channel
Front of vehicle
* Optional weld pattern
*
Driver-side shown
WARNING
Read pages 2 - 4 of this installation manual before beginning the
installation. Failure to do so could result in significant vehicle damage.
Check for obstructions prior to drilling. Failure to do so could result in
damaged fuel or brake lines, structural members, etc.
CURT does its best to communicate tow vehicle manufacturer
changes. However, it is ultimately the responsibility of the installer
to prevent damage due to installation.
IMPORTANT NOTES
Part #16302 spacer kit is required. Stack one 3/16" and one 5/16"
slotted spacer, as required, to avoid crushing the truck bed.
*
King pin center - approx.
1-1/4" forward of axle center