Installation Guide

CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8 634
•
RA
•
PAGE 18
.25
2
.25 2
*
.25 1.5-3
.25 2
*
Front of truck
Row 1 Row 2 Row 3 Row 4
Rear edge of truck bed
Each base rail must have a bolt in
either of the marked holes. Check
for obstructions before drilling.
Rear edge of the truck bed to
the rear edge of the base rail.
29-5/8"
long and short box
Axle center
Short bracket
VEHICLE-SPECIFIC INSTALLATION
Dodge full size through 1993
Long bracket
Mounting channel
King pin centered over axle
Front of vehicle
* Optional weld pattern
*
Driver-side of
1/2-ton Ram shown
IMPORTANT NOTES
You may need to move the base rail location +/- 1/2" to
ensure the frame brackets do not interfere with the bed sills.
WARNING
Read pages 2 - 4 of this installation manual before beginning the
installation. Failure to do so could result in significant vehicle damage.
Check for obstructions prior to drilling. Failure to do so could result in
damaged fuel or brake lines, structural members, etc.
CURT does its best to communicate tow vehicle manufacturer
changes. However, it is ultimately the responsibility of the installer
to prevent damage due to installation.
Bed sill
*