Installation Guide

CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8 634
•
RA
•
PAGE 17
.25 1.5-3
.25 2
*
.25
2
.25 2
*
Front of truck
Row 1 Row 2 Row 3 Row 4
Rear edge of truck bed
Each base rail must have a bolt in
either of the marked holes. Check
for obstructions before drilling.
Rear edge of the truck bed to
the rear edge of the base rail.
32-7/16" long box
28-7/16" short box
Axle center
Short bracket
VEHICLE-SPECIFIC INSTALLATION
Dodge 1500 94 - 01
Dodge 2500 / 3500 94 - 02
Long bracket
Mounting channel
Bed sill
Front of vehicle
* Optional weld pattern
*
*
Driver-side of
1500 Ram shown
IMPORTANT NOTES
It is very important that the brackets in row 2 are against the forward
side of the bed sill, as shown. Due to the dimensional instability in
the bed sill placement with the Dodge truck, interference could result
when drilling in rows 3 and 4. Observe the warning note above and
double check all areas prior to drilling.
You may need to move the base rail location +/- 1/2" to
ensure the frame brackets do not interfere with the bed sills.
WARNING
Read pages 2 - 4 of this installation manual before beginning the
installation. Failure to do so could result in significant vehicle damage.
Check for obstructions prior to drilling. Failure to do so could result in
damaged fuel or brake lines, structural members, etc.
CURT does its best to communicate tow vehicle manufacturer
changes. However, it is ultimately the responsibility of the installer
to prevent damage due to installation.
King pin center - approx.
2" forward of axle center