Installation Guide

ManualsBrandsCURT ManualsAuto PartsA25 5th Wheel Hitch, Select Silverado, Sierra 2500, 3500 HD, 8' Bed Puck System

Parts List

DESCRIPTIONPART NUMBERQTYITEM

HEX NUTM14 - 2 HEX NUT21

HEX HEAD BOLTM8 - 1.25 x 30 HEX BOLT22

LOCK WASHER5/16"23

WASHER1/4"

LOCK WASHER9/1625

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

* * * DO N OT E X CE ED V EH I C LE M AN U F ACT U RE R'S R EC OM M EN DED T OWI NG C AP AC I T Y .* * *

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.

* * FAI LU R E T O PR OP ER LY S U P PO RT N ON-T R AI LE R LOA D S W I L L V OID PRODU CT WARRAN T Y * *

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634

HITCH WEIGHT: LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERI ODI CALLY CH ECK T HI S RECEI VER H I TCH T O E N SU R E T H AT ALL FAST EN ERS

ARE T I GH T AN D TH AT ALL ST RU CT U RAL COM PON EN T S ARE SOUN D.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

2,000 200

JEEP SRT 8

7/14/2011

13003

24814 / 247103

1) Raise hitch into position as shown. Slide the rear bracket over existing 14mm studs protruding from the

bumper. Do not remove existing 14mm nuts.

2) Push the hitch up to make contact with the floor rib of the vehicle. Install (2) 8mm bolts with washers and

lock washers into existing weldnuts.

3) Install (2)14mm nuts with lock washers onto existing studs at the bumper beam.

4) Torque all 14mm fasteners to 94 lb-ft, and all 8mm fasteners to 17 lb-ft.

-NO DRILLING REQUIRED

-NO FASCIA TRIMMING REQUIRED