Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
15,000 1,500
89
N/A
UNIVERSAL WELD-ON RECEIVER HITCH
07/15/2020
15903
N/A
WELD PLATE TO FRAME
BOTH SIDES
SIDE PLATE
1. Locate where the hitch side plates will be mounted to the frame of the vehicle. Clean surface of frame in
weld locations down to bare metal.
*** Warning: *** If metal surfaces are not completely bare, weld will not be the required strength
and may void warranty.
2. Slide side plates onto the main body and raise into position to be welded. Secure/clamp side plates to
frame in position and center main body between side plates.
3. Weld side plates to frame of vehicle and main body, to AWS welding standards. Trim off any excess
main body beyond the side plates as desired.
60.88 in MAX.
18.00 in MIN.
SIDE PLATE
MAIN BODY
.25"
BOTH SIDE PLATES
11.500 in
- WELDING REQUIRED
(CLEAN ALL SURFACES)
- 2-3 PEOPLE RECOMMENDED
(3.220) in