Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
REAR VEHICLE
BULKHEAD
REAR VEHICLE
BULKHEAD
BUMPER BEAM
EXISTING 10mm - 1.25 STUDS
EXISTING 10mm - 1.25
HEX FLANGE NUTS
1. Remove the tail light plastic push fasteners with a straight
and phillips screw driver and the (2) screws with a 10mm
socket.
2. Pull each tailight rearward and unhook the wiring connector
to remove the lens.
3. Using a screw driver, remove the (3) push fasteners in the
rear wheel wells holding the bumper cover. If mud flaps
are present, remove the (3) screws holding on each side
as well.