Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
9. Temporarily unhook the kick sensor wire from the clips. Using
masking tape, mark out the 3.25" section in-between the
center sensor clips and trim using aviation shears. Reinstall
bumper fascia to vehicle following step 7 in reverse order and
reattach the kick sensor wire. Follow steps 1-6 in reverse
order to complete installation.
8. Raise hitch into position along with the bumper beam
and bumper beam bracket and secure with hardware
removed from step 7. Torque M10 hardware to 45 ft-lbs.
7. Gentley remove bumper fascia starting from the sides
and working towards rear of car. Set aside for later
reinstallation. Locate (8) M10 bolts on the bumper beam
and remove using a 16mm socket. Remove bumper
beam and bumper beam bracket.
3.25"