Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
6. Remove access panel on either side of trunk and
locate (2) nuts, (1) on either side, and remove
using a 10mm socket.
5. On the inside of the trunk locate (2) rubber plugs,
(1) on either side, and use the pry tool to remove
plugs to access (2) nuts, (1) on either side, and
remove using 10mm socket.
4. Remove trunk floor and use plastic pry tool to
remove trunk edge trim starting from the side.
3. Pull away wheel well trim to reveal screw and
remove using a T25 torxbit socket. Open liftgate
to reveal (2) screws. Remove using T20 torxbit
socket.