Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX FLANGE NUTHFN 121361
HEX BOLT1/2-13 x 5 1/242
WASHER1/2"163
.500 x 1.25 x 2.50" ROUND HOLE SPACERCM-SP526
4
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6000
600
36
30
9000
900
13297 / 78228 / RRH13297 04-06 DODGE DURANGO
7/18/2012
3
2
4
1
FRAME RAIL
BUMPER BRACKET
MUFFLER
1) Remove three bumper bracket nuts each side. Remove two rear most bolts each side.
2) Install supplied 1/2" bolts in locations where bolts were removed. Hang 1/2" thick spacers from each bolt
leaving flush with lip on bumper bracket.
3) Raise hitch into position over tail pipe. Attach with existing forward most bolts and fasten with existing nuts.
Fasten remaining bolts with 1/2" flange nuts.
4) Torque all 1/2" fasteners to 110 lb.-ft.
BUMPER BRACKET LIP
EXISTING FASTENER
-NO DRILLING REQUIRED
ADD WASHERS
AS NEEDED
(BOTH SIDES)