Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Fishwire (1) 7/16" carriage bolt and (1) CM-SP2 in through
access hole and out rearmost hole in driver & passenger
side frame rail.
4. Gently pull fascia down and raise hitch into position guiding
fishwires through mounting holes. Leave fishwires attached.
NOTE: Hardware may need to be temporarily pushed into
frame to position hitch over bumper beam studs. Remove
fishwires & loosely secure 7/16 nuts. Secure existing M10
nuts onto bumper beam studs.
5. Torque all 7/16" hardware to 59 ft-lbs and all M10 hardware
to 40 ft-lbs.
OPTIONAL:
Re-install hitch panel cover removed in STEP 1. Secure
screws with T15 torxbit socket.