Owners manual

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Gently pull the bumper fascia off starting from the
sides of the vehicle and work towards the center.
Once bumper fascia is detached from the vehicle,
locate and unplug (2) electrical plugs from the bumper
fascia. Set bumper fascia aside for later reinstallation.
4. On the bumper beam, locate and remove (2) nuts
and (2) bolts on each side using a 15mm socket. Lift
the exhaust bracket from each side away from the
vehicle frame to remove bumper beam. Set bumper
beam aside for later reinstallation.
5. Raise hitch and bumper beam into position aligning
with studs on vehicle. Secure using (2) nuts on each
side from previous step. Raise exhaust brackets back
into position and secure using (2) bolts on each side
from previous step. Torque all hardware to 45 ft-lbs.
6. Mark out a 4.375" x 2.25" section on the bumper
fascia centered from the hole using masking tape
and trim using aviation shears. Reinstall bumper
fascia following Steps 1-3 in reverse order.
4.375"
2.25"