Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 350
45
60
NISSAN QUEST
11/26/2012
12061
120
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12 - 1.25 x 40 HEX81
CONICAL TOOTHED WASHER1/2"82
1. Remove two rubber plugs from each side of trunk pan from inside of vehicle. This is done by carefully pulling
back the carpet on each side.
2. Remove tow hook by removing hardware through access holes in trunk pan and then remove hardware from
underneath vehicle. Put tow hook and hardware in bag and return to vehicle owner.
3. Raise hitch into position. Loosely install bottom bolts and washers.
4. Loosely install bolts and washers through access holes in trunk pan.
5. Torque all M12 hardware to 86 ft-lbs.
6. Replace rubber plugs in trunk pan and tuck carpet back into orginal position.
TOOLS REQUIRED
18mm & 19mm SOCKET
RATCHET
9" EXTENSION
TORQUE WRENCH
NO DRILLING REQUIRED
INSTALLED HITCH POSITION
BUMPER
FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #D-20
EURO MOUNT OPTION AVAILABLE
#45561 (1 7/8" BALL) AND #45562 (2" BALL)