Installation Guide

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, CURT
Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the
warranty. CURT Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
TOYOTA AVALON, CAMRY
10/4/2019
11576
PAGE 2 of 2
1.Lowerexhaustbyremoving(2)rubberisolatorspermufflerand(1)rubberisolatorforwardofthemuffler.
OnJapanbuiltvehicles:
removetiedownbracketfrompassengersideframerail.OnUSAbuiltvehicles:
removerearexhausthangerfromdriversideframerail.Ondualexhaustvehicles:removerearexhaust
hangerfrombothframerails.Saveforreinstallation.NOTE:
Supportexhausttopreventdamage.

2.RemoveheatshieldsandtrimusingHEATSHIELDTRIMDIAGRAMforreferenceandreinstall.
RemoveplasticunderbodypanelandtrimusingPANELTRIMDIAGRAMforreference.Saveforreinstallation.

3.Enlargeaccessholeinbothframerails.Reversefishwire1/2"carriageboltandCM‐SP10spacerintoeach
enlargedaccesshole.

4.Raisehitchintopositionandsecureusingtheprovidedhardwarewhilereinstallinganyremovedexhaust
hangers.TorqueM12hardwareto79ft‐lbs,M8hardwareto23ft‐lbs,1/2”hardwareto110ft‐lbs.
ReinstallplasticunderbodypanelremovedinStep2.
4.25 in
2.00 in
PANEL TRIM DIAGRAM
HEAT SHIELD TRIM DIAGRAM
1.00 in
3.25 in