Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
WARNING: ** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY **
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
2,000 200
28
60
TOYOTA AVALON, CAMRY
10/4/2019
11576
120
Scan
for more
information
PAGE 1 of 2
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT, CAR,1/2-13 UNC,1-1/2,GRD8,YZ10-1028721
HHCS,M12x1.25,45,CL10.9,YZ10-1033122
FB,M8x1.25,35,CL10.9,YZ10-1033343
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-000622
4
WASHER, S-CON,1/2,YZ
30-0014925
.250 x 1.00 x 2.50" SQUARE HOLE SPACERCM-SP10
26
1/2" FISHWIRE1_2 FISHWIRE
27
7
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALL MOUNT # 45521
EURO MOUNT OPTION AVAILABLE
#45571 (1 7/8" BALL) & #45572 (2" BALL)
EXISTING WELDNUTS
IN ALL FRAMES
EXISTING M12 WELDNUTS ON
VEHICELS BUILT IN JAPAN
EXISTING M8 WELDNUTS ON
VEHICLES BUILT IN US
ACCESS HOLE
BOTH SIDES
- TRIMMING REQUIRED
- NO DRILLING REQUIRED
TIE DOWN BRACKET ONLY ON
VEHICLES BUILT IN JAPAN
EXHAUST
HANGER
EXHAUST
HANGER
1
6
5
2
3
4
TOOLS REQUIRED
10mm, 12mm, 13mm SOCKETS
17mm, 19mm SOCKETS
RATCHET
TORQUE WRENCH
DIE GRINDER
CUTOFF WHEEL
MASKING TAPE
SAFETY GLASSES
TAPE MEASURE